Reflow Oven,Pick and Place Machine,Wave Soldering,Small Benchtop SMT,Stencil Printers,PCB Magazine Loader
Products Category
Contact Us

Name: Beijing Glichn S&T Development Co.,Ltd
Tel: +8610-58494188 +8610-65734544
Fax: +8610-65734544
E-mail: info@smtchn.com
Add: Floor 17th,Building No.6,Area 7th,ChaoXinJiaYuanDongLi,Chaoyang District,Beijing,China
Skype: GLICHN

News

• SMT technology • Package sizes introduction • Reworking defective SMD compon • Assembly components techniques • SMT placement equipment

Partners
DHL UPS EMS fedex paypal VISA GLICHN
News

Through Hole Technology

Author:Glichn Date:9/24/2011 9:03:58 AM
Through Hole Technology
Through Hole technology is a method for constructing electronic circuits in which the pin-through hole (PTH) components are inserted through holes drilled into printed circuit boards (PCBs). The ends, or leads, are then affixed to pads on the opposite side with molten metal solder using wave soldering or reflow soldering equipment. This process is also called through hole assembly.

Through Hole technology replaced early electronics assembly techniques such as point-to-point construction. From the second generation of computers in the 1950s until surface-mount technology became popular in the late 1980s, every component on a typical PCB was a through hole component.

While through hole mounting provides stronger mechanical bonds than surface-mount technology techniques, the additional drilling required makes the boards more expensive to produce. It also limits the available routing area for signal traces on multilayer boards since the holes must pass through all layers to the opposite side. For these reasons, through hole mounting is normally reserved for bulkier components such as electrolytic capacitors or semiconductors in large packages that require additional mounting strength to endure physical stress.