Manual chip production line

Manual chip production line is workers simulate pick and place machine, placing chips by chip pens; Chip pens take SMD components from belts and then put them on correct PADS by air pressure suction; Chip suction pen is more stable and high efficiency than tweezers; Taking components from belt directly can avoid components waste; And there is no positive and negative problem, that improves working efficiency; Chip suction pen absorb components back, that can avoid damaging edge and PADS by tweezers, so that can avoid solder connecting and solder bridge;

Manual chip production is used with Automatic SMT production, it is very important for improving manufacture efficiency and placing abnormal components;

Manual chip production line is the good choice for small and middle production, research, prototype and universities.

Manual speed: 2—3S/pc

Component Rack: 30 pcs (90 ring components can be put)

Chip production line: 1

The conveyor is necessary for double sides solder;

Worker: 30 workers to put SMT and IC;

Speed: （60S/3~2S）*60 Min *8 H*30 Workers =288000~43200 pcs/day

A）40W cover bracket and Philips light tubes, total is 18 sets;

B）38mm quadrate pipe

C）φ20mm stainless steel round pipe

D）PCB tray, 1*1.5 inch Aluminum guide;

E) SMD component rack: Every working station is with SMD component rack 3 rings components*2 sides, total is 30 working station; light shelf with removable stainless steel is used to put SMD components, guide is adjustable: 25—300mm

F) 18mm plywood with white fire-proof board and white wood edge from Indonesia

G) 38mm angle iron

H) 25mm quadrate pipe

I) Aluminum groove shelf (Green and transparent)

Double Acrylic Plate: W320mm*L12m*2 sides